Using your source control manager
The PowerBuilder SCC API works with your source control system
to perform certain source control operations and functions described
in the next section. Other source control operations must be performed
directly from the source control management tool. After you have
defined a source control connection profile for your PowerBuilder
workspace, you can open your source control manager from the Library
painter.
To start your source control manager from PowerBuilder
-
Select Entry>Source Control>Run Source
Control Manager from the Library painter menu bar.The menu item name varies depending on the source control
system you selected in the source control connection profile for
your current workspace. There is no manager tool for the PBNative
check in/check out utility.For information on configuring a source control connection
profile, see “Setting up a connection
profile”.
Which tool to use
The following table shows which source control functions you
should perform from your source control manager and which you can
perform from PowerBuilder:
|
Tool or interface |
Use for this |
|---|---|
|
Source control manager |
|
|
PowerBuilder SCC API |
|
* You can perform these source
control operations from PowerBuilder for some source control systems.